Skip to main content

Saw cut of wall, road base install

Today we had the top of the retaining wall cut to give it an even edge. This will of course need to be rendered to provide a very smooth looking finish, however this is the required first step to give the top of the wall its intended form. Also delivered today was the road base for prep of the driveway concrete pour next week.  Aggy pipes and geo textile fabric were delivered as well, ready for install tomorrow. Things are going like clockwork on this project!




















Comments

Post a Comment

Popular posts from this blog

Footing steel installed and a much needed arrival

Toe footing steel RW2 section was installed, excess dirt and rocks were taken away and the toilet arrived on site (very good news)
Post a Comment
Read more

Final Section Concrete Pour

It's been a long time coming, but we finally made it to the last concrete pour of this driveway. The last section took 16 cubic metres of concrete and we proved today that a concrete truck with 5 cubic metres of concrete can reverse up the driveway with no trouble at all. This says a lot about the strength and planning of such a driveway given the slope. It also has greater meaning for the house build - all footings and slabs will have easy access for the trucks in the future! Pete, Will and Clynton were on board today to finish the final section, which looks great - well done guys.
Post a Comment
Read more

Stage 2 of driveway (top section) started.

We have finally started on the Stage 2 of the driveway - after literally months of rain.  We could not have stopped the last stage at a better time - it was hammering down with rain 3 days after we completed stage 1. Peter is again available so we are going all out to finish Stage 2.  After sorting out where the garage will be placed (thanks Chris) in order for the driveway to meet up correctly from its current position, we are now ready to install the top section.
Post a Comment
Read more